Summit & Slate Roofing installs and repairs flat & tpo roofing across Aurora, from Paramount Theatre on Stolp Island to Fox River and the RiverEdge Park amphitheater. Aurora is the second-largest city in Illinois and the largest in Kane County, and its roofs run the full spectrum because its housing does. Downtown around Stolp Island and the Tanner district you have brick and frame homes from the late 1800s and early 1900s, many with steep gable and dormer rooflines and original wood decking. Out on the Far East Side off Route 59 and Eola Road you have subdivisions built in the 1990s and 2000s whose first-generation builder-grade shingles are now failing on schedule. We replace both, and we price each one for what it actually needs.
Aurora sits in the Fox River valley, where cold air settles overnight and stretches freeze-thaw cycles longer than on higher ground. River-valley humidity feeds heavy ice dams on the shaded north slopes of older East Side homes. Summer brings the same hail and 60-plus mph derecho gusts that hit the rest of Kane County, and west-facing roofs along open farmland on the far east side take the brunt of straight-line wind with no tree cover to slow it.
What our Aurora flat & tpo roofing includes
Every Flat & TPO Roofing job in Aurora includes:
60-mil TPO membrane installation
We install 60-mil TPO as our standard, not the thinner 45-mil builders use to cut cost. The extra thickness handles foot traffic, hail, and ladder contact far better, and it carries a longer manufacturer material warranty on top of our 25-year workmanship coverage.
Hot-air welded seams
Every TPO seam is welded with a robotic or hand hot-air welder so the sheets fuse into one continuous surface. Welded seams are the single biggest difference between a flat roof that lasts and one that leaks. We never rely on seam tape or adhesive at the laps.
Tear-off of failed EPDM and built-up tar
We remove old rubber, tar-and-gravel, and mod-bit roofs down to the deck, replace any rotted sheathing, and check the slope before the new membrane goes on. Layering TPO over a failing roof traps moisture and voids warranties, so we tear off.
Tapered insulation and proper drainage
Standing water is the enemy of any flat roof. On dead-flat decks we add tapered polyiso insulation to build positive slope toward drains or scuppers, raising the R-value at the same time. This stops the ponding that shortens membrane life on Wheaton low-slope additions.
Flashing, curbs, and penetration detailing
Skylights, HVAC curbs, vent pipes, and wall transitions are where flat roofs leak first. We flash every penetration with TPO-coated metal and pre-molded boots, then weld them into the field membrane so there is no exposed sealant doing the work alone.
How much does Flat & TPO Roofing cost in Aurora, IL?
| Repair | Typical range | Time on site |
|---|
Quoted from photos before work starts, the price you approve is the price you pay.