Summit & Slate Roofing installs and repairs metal roofing across Naperville, from The Naperville Riverwalk along the DuPage River to Naper Settlement. Naperville is two roofing markets in one ZIP map. East of Washington Street, the Historic District holds homes from the early 1900s, many with steep original pitches, narrow soffits, and a couple of decades of patch jobs stacked on top of each other. West toward Route 59 and 248th Avenue, subdivisions like White Eagle, Tall Grass, and Ashbury went up through the 1990s and early 2000s, and those original builder-grade 3-tab and entry architectural shingles are now hitting 25 to 30 years old all at the same time. We replace both, and the approach for each is not the same.
Naperville sits far enough inland that lake-effect snow off Lake Michigan still drops 30-plus inches a winter, and the freeze-thaw swing between January nights below zero and 40-degree thaw days drives ice dams along the long north-facing slopes common on the big subdivision homes here. Summers bring hail and the occasional derecho straight-line wind off the prairie, which lifts and creases architectural shingles on the tall, multi-gable rooflines west of Route 59.
What a standing-seam metal roof includes
Every Metal Roofing job in Naperville includes:
24-Gauge Standing Seam
Our most-installed metal system for Wheaton and Glen Ellyn homes. Concealed-clip panels with 1.5-inch or 1.75-inch seams, mechanically or snap-locked, in 24-gauge steel. No exposed fasteners on the field means nothing to back out or leak over 30-plus freeze-thaw winters.
Exposed-Fastener Panel Roofs
A budget-friendlier option, often used on detached garages, porches, pole barns, and outbuildings around Aurora and Lisle. We install 26-gauge through-fastened panels with EPDM-washer screws driven to correct torque so the gaskets seal without crushing.
Standing Seam Over Low-Slope Sections
Many local ranches and mid-century homes have low-pitch porch and addition roofs below 3/12. We spec mechanically seamed panels with sealant in the seam, rated for the low slopes that snap-lock systems can't safely cover in our snow load.
Metal Over Complex Hips and Valleys
Newer Naperville subdivision roofs are full of hips, dormers, and dead valleys. We custom-bend valley pans, hip caps, and headwall flashing in-house on our brake so every transition is watertight, not patched with caulk.
Full Tear-Off and Deck Repair
We tear off to the deck, replace any rotted or delaminated sheathing, and install a high-temp synthetic or peel-and-stick underlayment rated for metal before a single panel goes down. Crews are ours, never subcontracted.
How much does Metal Roofing cost in Naperville, IL?
| Repair | Typical range | Time on site |
|---|---|---|
| Standing-seam panels26-gauge, concealed fastener | $20,000 to $45,000 | 3 to 5 days |
| Ridge, valley and flashing detailSealed penetrations | $2,500 to $6,000 | Included |
Quoted from photos before work starts, the price you approve is the price you pay.